Braun - golarka męska Syncro 7540, █▬█ █ ▀█▀ NOWOŚCI Instrukcje obsługi sprzęt AGD
[ Pobierz całość w formacie PDF ]
7540
Type 5492
Braun Infoline
English
4, 49, 55
TR
Türkiye’deki Tüketici Danı¸ ma Servisi:
0 800 261 19 53
Français
8, 49, 55
Magyar
12, 49, 55
âesk˘
16, 50, 55
Slovensk˘
20, 50, 55
Hrvatski
24, 50, 55
Polski
28, 51, 55
Türkçe
32, 55
36, 51, 55
40, 52, 55
48, 54, 55
Internet:
www.braun.com
5-492-453/01/XI-00
GB/F/H/CZ/SK/HR/PL/TR/RUS/UA/Arab
Printed in Germany
Syncro 7540
1
2
No. 7000
3
4
4
5
6
7
8
9
10
English
Our products are designed to meet the highest standards
of quality, functionality and design. We hope you enjoy
your new Braun shaver.
Important
Only use the power supply cord set provided.
A damaged cord must be replaced immediately.
Description
1 Foil protection cap 7 Charging lights
2 Shaver foil
(green)
3 Cutter block
8 Low-charge light
4 Foil release button
(red)
5 Long hair trimmer
9 Pilot light
6 Switch
10 Shaver socket
Technical specifications:
• Wattage via cord set: 7 W
• Power supply via cord set: 100-240 V
2
/50 or 60 Hz
(automatic adaptation)
• Shaver input voltage: 12-24 V
Charging the shaver
•
First charging
: Using the power supply cord set,
connect the shaver to the mains with the switch
on position «0» and charge it for
at least 4 hours
(plug might get warm).
+35
°
C
• Once the shaver is completely charged, shave without
the cord until fully discharged. Then recharge to full
capacity again (subsequent charges will take about
1 hour).
+15
°
C
• A full charge will give up to 50 minutes of cordless
shaving time depending on your beard growth.
However, the maximum battery capacity will only be
reached after several charging/discharging cycles.
• Best environmental temperature range for charging is
15 °C to 35 °C.
Indicator lights
• The pilot light shows that the shaver is connected to
the mains.
4
• When the rechargeable battery is fully charged, all five
charging lights illuminate (20% per light), provided the
shaver is connected to the mains or switched on.
• The red low-charge light flashes when the battery
capacity has dropped below 20%, provided the shaver
is switched on. The remaining capacity will then be
sufficient for 2 to 3 shaves.
Shaving
Switch positions
0 = Off (switch is locked)
Press and push up the switch to operate the shaver:
1 = Shaving with the pivoting head
The pivoting cutting system automatically adjusts
to every contour of your face.
2 = Shaving with the pivoting head locked at an angle
(to permit shaving in difficult areas, e.g. under the
nose)
3 = The long hair trimmer is activated
(for trimming sideburns, moustache and beard).
Shaving with the cord
If the rechargeable battery is discharged, you may also
shave with the shaver connected to the mains via the
power supply cord set.
(If the shaver does not run immediately, charge it with
the switch on position «0» for approx. 1 minute.)
Tips for the perfect shave
• We recommend that you shave
before
washing,
as the skin tends to be slightly swollen after
washing.
• Hold the shaver at right angles (90°) to the skin.
• Stretch your skin and shave against the direction
of beard growth.
• Replace the shaver foil and cutter block every
1
/
5
years, or when the parts are worn, to ensure
optimum shaving performance.
1
2
[ Pobierz całość w formacie PDF ]
zanotowane.pl doc.pisz.pl pdf.pisz.pl lemansa.htw.pl
7540
Type 5492
Braun Infoline
English
4, 49, 55
TR
Türkiye’deki Tüketici Danı¸ ma Servisi:
0 800 261 19 53
Français
8, 49, 55
Magyar
12, 49, 55
âesk˘
16, 50, 55
Slovensk˘
20, 50, 55
Hrvatski
24, 50, 55
Polski
28, 51, 55
Türkçe
32, 55
36, 51, 55
40, 52, 55
48, 54, 55
Internet:
www.braun.com
5-492-453/01/XI-00
GB/F/H/CZ/SK/HR/PL/TR/RUS/UA/Arab
Printed in Germany
Syncro 7540
1
2
No. 7000
3
4
4
5
6
7
8
9
10
English
Our products are designed to meet the highest standards
of quality, functionality and design. We hope you enjoy
your new Braun shaver.
Important
Only use the power supply cord set provided.
A damaged cord must be replaced immediately.
Description
1 Foil protection cap 7 Charging lights
2 Shaver foil
(green)
3 Cutter block
8 Low-charge light
4 Foil release button
(red)
5 Long hair trimmer
9 Pilot light
6 Switch
10 Shaver socket
Technical specifications:
• Wattage via cord set: 7 W
• Power supply via cord set: 100-240 V
2
/50 or 60 Hz
(automatic adaptation)
• Shaver input voltage: 12-24 V
Charging the shaver
•
First charging
: Using the power supply cord set,
connect the shaver to the mains with the switch
on position «0» and charge it for
at least 4 hours
(plug might get warm).
+35
°
C
• Once the shaver is completely charged, shave without
the cord until fully discharged. Then recharge to full
capacity again (subsequent charges will take about
1 hour).
+15
°
C
• A full charge will give up to 50 minutes of cordless
shaving time depending on your beard growth.
However, the maximum battery capacity will only be
reached after several charging/discharging cycles.
• Best environmental temperature range for charging is
15 °C to 35 °C.
Indicator lights
• The pilot light shows that the shaver is connected to
the mains.
4
• When the rechargeable battery is fully charged, all five
charging lights illuminate (20% per light), provided the
shaver is connected to the mains or switched on.
• The red low-charge light flashes when the battery
capacity has dropped below 20%, provided the shaver
is switched on. The remaining capacity will then be
sufficient for 2 to 3 shaves.
Shaving
Switch positions
0 = Off (switch is locked)
Press and push up the switch to operate the shaver:
1 = Shaving with the pivoting head
The pivoting cutting system automatically adjusts
to every contour of your face.
2 = Shaving with the pivoting head locked at an angle
(to permit shaving in difficult areas, e.g. under the
nose)
3 = The long hair trimmer is activated
(for trimming sideburns, moustache and beard).
Shaving with the cord
If the rechargeable battery is discharged, you may also
shave with the shaver connected to the mains via the
power supply cord set.
(If the shaver does not run immediately, charge it with
the switch on position «0» for approx. 1 minute.)
Tips for the perfect shave
• We recommend that you shave
before
washing,
as the skin tends to be slightly swollen after
washing.
• Hold the shaver at right angles (90°) to the skin.
• Stretch your skin and shave against the direction
of beard growth.
• Replace the shaver foil and cutter block every
1
/
5
years, or when the parts are worn, to ensure
optimum shaving performance.
1
2
[ Pobierz całość w formacie PDF ]